Don't forget the multiple ground wires to frame behind and up above the wiper motor.
Also don't forget that there is a tiny leather gasket between the oil gauge and the oil line. If you forget this gasket you will have a oil leak under your dash. (Moss part #435-516 Leather washer for oil gauge)
If you loosen (3 big bolts at the mid front 9/16 and 3 smaller 1/2 at the base mounted to the fire wall) and lower lower/swing downward the steering column it make it easier to install the shroud/cover over the turn and wiper assembly.
Great progress on you beautiful car.

Thanks for an excellent video! '73B

ありがとう😊　よく分かりました。　　Thank you❣️😊

I wished you'd talked about the wood. It looks great.

Sorry, me again.  Also there are 2 wires, purple/pink and purple/green.  I can't find where they go either.

Thanks for the video! I'd like to know what those green wires with the female bullet connectors near the diodes go to. They were just hanging not connected. They were behind those black connectors with the green wires.

Where did you get the dash? It looks new.

Great work. I have a question. When taking off the dash It was very hard to get to the six bolts at the top of the dash. I had to remove some of the gages. I would like to put the gages back in like you did but I am worried about getting to the six bolts at the top of the dash.

Hello again Alex. I am finally putting my dash back in and I was just wondering.  I have an extra 3 prong connector on my main harness.  It has a double red/green in 1, double brown in 2 and a blue in 3.  I don't have a matching connector on the dash harness.  Did you have this same problem?  I can't find a connector for it.

Alex, I’ve just replaced my dash. It was quite a project but I got the whole dash unit so I couldn’t not do it. If you saw the old one I’m sure you’d agree!

My questions are on the wood panel:
1.) Is it in fact wood? You may have already answered that but please remind me. The Moss catalogue refers to wood on MGB’s up to but not including the final generation.

2.) If I were to install the “wood” dash and later wanted to remove it, would I ruin the dashboard?

Thanks

PS so now that you’ve done the MGB what’s next?

While I appreciate the time it took for you to produce this video, once I saw you were using "scotch lock" type splices I stopped watching.  It is never acceptable to use these cheap splices for automotive wiring.  This is a wiring disaster that will ultimately destroy all your hard work and expense of installing a new wiring harness!