🍀

Nice video. Check into a process sheet, they will save you a lot time. In my opinion personal project should always be taken slowly. lots of mistakes can be avoided. Good luck.

Very interesting video. Nice work mister

❤

😊😊

😊

Thankyou for a very interesting video, and a good job done very well.

Hi why did you not use a good size Alan key bolt to hold the fly wheel on to the arber because if you had you could have made the Alan key bolt head sit flush with the bottom of the fly wheel surface wich would give you more room to work with on the milling machine

That is an impressive looking fly cutter, though there appeared to be one small issue with it.
Please correct me if I am wrong, but the cutting edges don't appear to be in line with the center of the cutter, they seem to be leading it by about 10mm...
I'm only asking since most, if not all machinists I have seen online say its best to keep it in line with the tool center