This is the best video I have found to explain how one of these works. Thank you.

Nice to see and have explained. Most people just try to explain centrifuge and are afraid to run the system open like that.
Great Job.

Great video..thanks for taking the time to share

Excellent tutorial, thank you

Thank you for being very informational. I watched a couple of your videos and they are awesome. I'm thinking about following what you are doing and use it for my diesel generator :)

Excellent demo of this operation

There are two lines out of the fuge...the one is clean oil when on and the second is for the fmdirty when you turn it off...it drains to a 5 gallon bucket

i dont get it. the drain is at the bottom. none of the spinning oil reaches the bottom but the oil being dripped in reaches the bottom?
it seperates the oil by letting the oil that first reaches the drain holes...? that would mean spinning it and then letting it mix again, there has to be a better way than this

enjoyed the video. for a WMO recycling project I want to install a brass bulkhead into a barrel so I can control the draining from the bottom to the centrifuge. I figure the brass will hold up better than plastic. it comes with a washer but will it seal better if I use something like JB Weld on it? or is it unnecessary? I'm concerned about the effect of petroleum on the bulkhead and seal. thank you for any assistance you can provide.

Lovely, I have been looking for one. At what rpm is the motor rotating?

Καλό βίντεο σύννομε.

Thanks for sharing

Hello
Sir, if it was a concussion in the rotating cylinder, does it affect the results?

Sounds like an aca P50 tornado siren at full speed

Κωνσταντίνε καλησπέρα από Αθήνα. Ψάχνοντας για Black diesel έπεσα στο βίντεο σου! Θα μπορούσες να εξηγήσεις αν μετατρέπει τα καμένα λάδια από αυτοκίνητα ή από κιβώτια ταχυτήτων κλπ καθως και την γνώμη σου για την μετατροπη(αν είναι ασφαλές, αν αυτά που πωλούνται είναι αξιόπιστα και ο, τι άλλο νομίζεις?)

Waw thank you

Do we have a part# for this thing? I cannot find it to save my life.

I've looked all over the Internet for that machine where the hell did you buy that machine from I want one and I can't find one anywhere

How much $$ do these cost?  How many rpms does it turn?  Sounds like its quieter than some c/fuges.

thank you for share your information