UPDATE: I finally got to use the Arbor Press with the metal stamping tool!  OMG!  This is wonderful!  I'm so glad for the internet!  I honestly cannot wait to use it again.  It wasn't as hard on my wrist as the banging of a hammer was before (it didn't help the carpal tunnel either).  :)  Thanks for creating this tool! :)

I am so happy to see this video because it gives a lot more information on how to use the metal stamping tool. This is super helpful!

Thank you for the video. Personally, I would use an x-y vise, which can be picked up for like $50. Then you can just move it along in a line perfectly and get your letters in a straight line without a piece of tape.

Thanks for considering making the video- I was lost and discourage- I have B insert.

Is that the 1 ton Arbour press? I'm looking to buy a press and have been looking at the 1 ton ones. I'd like to get one of those stamp attachments if the attachments will fit the 1 ton Arbour press. But not if it's a different one.

hi, for those of you that use a 1/2 ton arbor press...
what ga metal do you use with it?
i bought one and a few design stamps a month ago, and i tried using 24ga dead stof sterling silver, nothing transfered, so i went to 26ga, and i got a little impression and a better one after i used a hammer on the ram, which i dont want to do. i thought i would just have to pull the handle down and then my design would be on the metal? maybe im just really weak? i just ordered 28ga but am worried that might be too thin.
i can never get the full design when i hand stam, i've tried the tilt n tap but always mess it up. letter stamps,numbers and simple designs i have no problem free handing on metals up to 24ga.

I have already an arbor press (Eurpean type).
The shaft is 24x24mm( a little less than 1"x1"). Would it fit with your attachments?

I have a one inch stamp, would I just buy the metal stamping tool attachment? Or how do I use a 1 inch stamp?
🔥🦈🌊

Do the weight lock on when pressing items

Here is the link to where you can buy all these items. She also has stamps. https://www.flatwearable.net/home/metal-stamping-tool/

Can you use this stamoing toll on a ring that's already formed? Thx!

Set up a fence

Thank you for the video. You are correct, before you start stamping you need to but these. Where can I purchase these attachments? Will they work with Beaducaton design stamps?

Do you have to special order attachments or do you have a store that sells them?

Link seems to be broken.

Do you need to put rubber under your press like when stamping by hand?

Hi... where do I purchase the pieces for the stamps. Thanks

I bought the tools and a one ton Arbor Press. My stamps fit but I am only getting a partial stamp. I am practicing on copper but want to stamp silver. On one You tube a guy is hitting the top of the shank but you are not.  Should I be able to just press the stamp? I feel Ike I’m pressing hard. Please advise.

the link to get the inserts and attachments doesn't work. Where can I find this? Thanks

I have not found the link under the video from your shop. Can you please tell me, where I can order the tool?

Where do you buy A , B and holder parts at ? Ty