I love mine! Works beautifully!!!

I hope the trimmer was not working at 02:15! 😅

That view from your yard of the mountains…….as Borat said “Very Nice!”

Also, noticed you are using the Tolco320 sprayer on your Pressol bottle. The Tolco is my favorite. Does it screw on well to the bottle?
Did your Pressol sprayer fail?

My experience with the A2000 and the A3000 has been far different. I live in the Chicago burbs. I cut my grass at 3.5" because while shorter heights are OK in spring, the Midwest hot dry summer will kill it if shorter.

My lot is 1/3 acre. Heavily landscaped so several shaded areas. The main problem I run into is the robots' missing spots. This is especially true of the lidar version. It has trouble with two situations #1, where the sun pokes through the tree canopy, producing a bright spot on the ground. My A300 will be going down the sidewalk (its pre planned path). It will see the bright spot and freak out. Because it's on a path and not a mowing area, it doesn't know what to do and freaks out and does a little dance for 15 minutes before it just gives up.

Problem #2 is with dark patches of grass. Even though these patches are not taller than 5, it will not cut them and will go around leaving little unmowed spots everywhere.

I've reached out to support, and they had me turn off AI recognition, which helped quite a bit.

The RTK (a2000) works fine, but you MUST permanently mount the antenna, or you are just asking for trouble and grief.

Lastly, the Lidar based A3000 gets lost and sometimes ends up in a flowerbed or worse in the street! I live on a corner, meaning I have a front street and a side street. The mower has slide down my curved curb and ended up in the street, and it seems to happen once or twice a week. Sometime,  it can drive back up the curb onto the gras,  but I've also seen it spin around and even back up further into the street which is worrisome.

This morning, I got a left /right wheel error (second time this week), and the mower was sitting a few inches from my neighbors car about a foot and a half past its boundry.

Lastly, my lidar unit has gotten stuck after it crossed its boundry and when I pushed it back onto the lawn it said it could not identify where it was and needed to be manually returned to its charging base.

I bought these because they were cheaper than the competition but I wish I had spent more. This is my second season with them.

As a final complaint, the app hasn't been updated, and if you set a cut angle, (I like about 60 degrees) you will never be able to set the same angle again because there are no degree markings in the app.

Hello, great video and thank you.

I have a fence, is this mower good for yards with a fence?

how often do you think blades ( and string tim) need replacing ( assuming not many rocks or twigs around ) ???

How do I get the trimmer to trim closer to the designated area. I map with the trimmer facing away from the edge that I am mapping.

First

What is your warm season grass type,Bermuda?

As these robot mowers get better and better,I see no need to buy a zero turn ,if they can eventually handle large plots

I have a Segeway Navimow i100 w/ GPS. I mow only the rear yard and down the center is a cement walkway that requires me to setup 2 zones. Will this mower act as though the sidewalk does not exist so that I can only have one zone?

The blades should be replaced every 80 hours, there is a countdown in the app. Also the blade rotation changed every mow cycle so no, you can not just flip them.

I had an a3000 goat pro and returned it.  It does cut very well but the edge trimmer is a gimmick. Does not get close enough to my fence which defeats the purpose.

Wow, looked like it got pretty close to your bare toes.