Great video for someone like me who is just starting out with reloading!  Thanks.

Interesting, my first experience hand loading was 45 auto with RCBS dies, I knew nothing then. My experience is nothing like yours. I cannot believe an experienced loader would have such a bad and insurmountable problem with a die set.

Thanks.  Another great how-to vid.

Great video!!!  Very informative, keep the Hornady videos coming!!!

Great video thanks .

Yea I’ve been using RCBS since 1970 and the only time any of your problem occurred, was when I screwed up. Competitive shooter and carry for a living.
So I’ve discovered after 100’s of thousands of rounds, that you do have to be smarter than a green plastic box.

Regular Alcohol from the Dollar Store Drug section works at removing any Film that is coated on the dies & Alcohol will not harm  any of the rubber parts on the die's

It does help if you stick to using the past or the present tense throughout.

I've been reloading with both hornady and rcbs for years.  The only time I ever crushed a case it was my fault, not the die's.

Don't worry, the dies will work on any press.  I have always bought the custom grade dies by Hornady.  There is a match grade, but never needed those especially for pistol loads.

no you have to buy the bushings separate, but some come with the press.

@BBill011 I hope I don't disappoint, but I'm in GA. BUT........ I'm extremely happy you liked the video !!!  I'll keep them coming.

Good note on the lighter fluid.. thanks.

Yeah, expanding the case mouth is sort of delicate.  If I do it too much then the bullet tends to fall in.  I'd rather have it a little small than too big, but that's just my preference.  

After I cleaned my Dies I brush the insides With some Motor Mica, it helps make the die's slick etc.

@BrandoMcWilli Not yet.  Going to check a gun show in Dallas this weekend to see if any great deals.  (I'll still buy from my local dealer...but he says he'll match any deal I find if I'll add 10%...I like supporting the local guy, especially since he got me into my gun club!)

Operator error!

My Win 308 cases were sticking into mt new Hornady Resizing Die even though I  Lubed the cases good, But I did not clean & degrease the new dies before using them, & make sure that that Hole in the die was not clogged, I am going to clean them good & try resize my Brass again etc.

Any idea where to get a replacement rod/decapping pin for an old Hornady 308 set with a internal
neck sizer

Look like they were not properly expanded at the end.

Of Hornady's latest selections, what is the best pistol die sets for the Lock and Load Classic? Can they be used on a Dillon RL550B press? I have ordered a Hornady Lock and Load and plan to, at some point, add a Dillon to the reloading bench so I need to know this before I purchase any dies. Thanks for your help and videos.