This voice. It’s like Christopher Walken, Elvis Presley and Bruce Lee and Muhammad Ali all in one.

The thing with all the angles on it is called a Protractor in English.

Thanks a lot!!!👍👍👍

Now that was amazing, man! Thank you so much!

Thanks for this wonderful tip, sir.

Hello Nejc, you have found the formula for making templates, great!, and by the way you english perfect, I am from Denmark, and have leaned my english in the school, like you i suppose, and i understand you better than when an englishman or an american i doing the speaking, keep up the good work!.

Thanks, Nejc. I understand the process for making the large template for the face and the heels, but I don't quite understand the relationship to the small template. The small template has to shape the correct angles to align with the heel facets on the large template.

Esta muy bueno el vídeo..me sirvió mucho..se nota que no sos de habla sajona..hablas español? Lo podrías repetir en castellano...yo le entendi barbaro pero seguro habrá gente que de le complica..y la verdad esta super bueno el vídeo...vale la pena repetirlo en castellano..ademas seguro vas a poder explayarte mas ! Muchas gracias !

Посмотрел в России с переводом  яндекса. Всё понял, большое спасибо! Буду делать!

Hi . Thank you for this video. It's very interesting. I would want to ask you a question. How do you choose the angles 40° and 15° ?  Why do you choose these values ?

Hello from France. pretty cool video. . .
can you please explain how to do a ruff cut.
thank you very much in advance.
good job.
cyril

In your video you wrote 45mm from right to left, making it 54mm — I have never seen it done that way. Please explain.

Hi Nejc, just wanted to say thank you for all the information in your videos, truly inspiring. I would like to ask a question I regards to the Lindsay sharpening templates that you use, do the angles on the larger template match the angles on the smaller roughing out template in correlation to the heel section, eg. On the 116degree larger template is that the same on the smaller template? Any information would be greatly appreciated

'Hey' can you do a video on how to make the ruff cut templates as well..👍🏻🔨

What did you make the center holder from?

And what are the dimensions of the small template to the large one. I correctly understood-the tip is 130 degrees and from the center, on two sides by = 25 mm. The side of the flat edge from the center is 25 mm (right? Or another size) And what is the radius of the two upper ones or their length In mm Please tell me!

Hi there,
amazing what you are doing.
I 'll try to copy the  things you showed.
2 questions: Where did you order the  3mm round carbide steel rods?  
How long is the hard plastic tube you put over the rod to be sure the rod is ...mm ?
Thnx advance man

They call it a protractor

Thank you so much for the video! I understand the geometry of the large template but I don’t know how to apply it to the small roughing out template. I have been struggling for some time now to achieve a parallel heel. Can you please explain how you use the geometry to make The smaller template? And with both made will it achieve a parallel heel? Any help would be so great appreciated as I am completely stuck. Thank you!

its call protactor i believe.. hahah thanks for the video.. i was almost going to spend $200 on some plastic graver templates sold on Lindsay Graver site.. ill try making it myself now.. i was wondering what Lindsay graver templates you own and where do you buy your graver blanks?