OpenTube

Scx24 4ws! //Scx24 Jeep gets 4wheel steering fast and easy install//

UpperLeft RC

12,102 views

In this video I gut the remains of the dead Baby Grave Digger and install 4wheel steer on the Jeep Rubicon, I promise Digger will be back with a vengeance but for now its a parts donor for this awesome project! super easy and fun install and the rear steer works awesome!

20 Comments

@creekcreeperrc7972 4 years ago

Everyone feels like that when trying four wheel steering for the first time, it seems like to much work and to hard to use fluidly. I recommend only use it when you really need it then you will slowly learn to steer the rear as accurately as your front. Great build man 👍🏻👍🏻

@helmesnick79 4 years ago

Maybe a self cantering control for the rear steer

@DrakeRc 3 years ago

Yea v2 would be all around better as the ch3 switch is in a better spot too 👍

@Game4Hours 3 years ago

Awesome! 😁👍👍 I did my Axial Deadbolt 4 wheel steer

@Sean1974 4 years ago

So cool that you had all this stuff already outside to build on.

@DrakeRc 3 years ago

It would also be easier with a v2 then you could set the end points and set center

@p74_crownvic 5 years ago

Put rear steer on baby digger to be like a real monstertruck.

@jpyt7182 5 years ago

😂 the jeep on the treadmill 👌

@renercadventures 5 years ago

Nice installation thanks for sharing 😊👍

@juanrascon7743 5 years ago

That opening was AWESOME😂😂😂😂

@onffworld6357 5 years ago

Really nice❗❗❗

@docedits7294 4 years ago

get a splitter and a reverse signal wire and itll all be on steering. No switches

@islandrc-duke1972 5 years ago

Awesome mod,cool RC,subbed

@JaysensRCs 5 years ago (edited)

Love it.. now I Am going to have to do it to my deadbolt/C10 project...😆😁 Great job on the outdoor course by the way RC sparks was also my inspiration in building mine..

@DrakeRc 3 years ago

The wheel weights didn't work because the heavier ones you have are only made for stock wheel, its because the hex doesn't stick out is why it doesn't fit you'd have to grind down the part on the outside around the hex not bevel thenhex head if that makes sense

@fritzdallmann2139 5 years ago

You are flippin hilarious

@jpyt7182 5 years ago (edited)

With the rear steering conversion you could run OD gears front and rear, finish it off with a brushless motor, that handy dandy furitek 3s main board and a 3s battery. 😂 I think that would be pretty interesting. A scx24 rock bouncer or racer if gears got done 😂

@Skeldons 3 years ago

Flysky gt5 has 4ws mix controls. Crab walk, 4w opposite steer, just rear and just front. It also has a dial to steer the rear wheels at the same time as the front. Did you figure this out eventually?