Really helpful video. Rest in peace Stephen.

So grateful for this video!

Helpful video, thanks

(Stephen was a good guy ) RIP

Just a note on this side presentation; To contact me on Facebook go to my name or Phenomenal Facets on Facebook. The Phenomenal facets. com website is no longer in existence and has been shut down for quite some time now... so go to Facebook to reach me. ;)

i used pb blaster because I didn't have WD is that ok?  i just presumed they're same stuff different brands

for people asking about the Norbide stick / Boron carbide stick the best place to get this is on ebay... also the diamond grit shown here in the slide show is for 8k or 8000 diamond on copper for pre polishing most stones but especially Sapphire, CZ, YAG, Garnet ect it eliminates any undercutting or orange peel from a 1200-1500 lap and is what I'm showing here on how to properly prep the copper lap for either 8k prepolish or 50k-100k+ for polishing, though the laps surfaces will look different for the pre polish as it will be oilier with crystal lube used as opposed to polish which is very dry with only one drop of WD40 used. here is the link I use for the Boron carbide stick on ebay;
http://www.ebay.com/itm/281069355184?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

should the same process be done with a zinc lap?

Where can the Norbide Stick that is shown be purchased?

Where i can buy norbide

Kodei Muito Po
Aki
Pral

Como, faço pra, como, uma, máquina, desta, obrigado

Dimana boleh mendapat mesin cutting permata Di malaysia

Are these discs copper?
And can you give me some information on where to get it?