Oh dear Martyn, sorry to hear about your dad matey. Send him our best wishes for a speedy recovery. 👍👍👍

I hope Your Dad fully recovers!!! The amp sounds great. I have the combo version. Rock on!!!!!

Sorry to hear about your Dad Martyn,hope he makes a good recovery.

I hope your dad makes a speedy recovery.  It must have given you a heck of a fright when you found him in the morning, just as well it's not the middle of winter.  Keep well yourself.  Regards, Jeff.

That's a great amplifier to finally see inside with a schematic. Always wanted a look. Thank you.
Good Luck & a prayer for your Dad❤

Thanks for another great video.

Very sorry to hear that your Father had a mishap. For someone who hasn’t picked up a guitar all week, you sound really good.  

Looking forward to the next one.  Take care

Hi Martyn thanks for the content ! Sorry to hear of accident. Hope Dad gets well/ better soon

That's a fine amp.

All the best for your dad making a full recovery. The opportunity to chat up the nurses might make him less grumpy for a wee while.

Nice clean on the amp. Sounds like it would take distortion pedals well. Not all amps do -- for some reason that I still do not quite understand (i think it might be less about clean headroom and more to do with topology, grid resistor values for the first gain stage, preamp valve biasing including cathode set up, and tone stack etc).

Rusty my ass! Love your playing, great selection

Sorry to hear of your Dads fall. Probably a few more days of not getting much done when he gets out of hospital.   Keep smiling. Best wishes

Orange makes great amps! Love the OR30, TH30 as well as the Rockerverb 100 MKIII. Even purchased the Super Crush 100 for my son and he enjoys that as well and TBH does not sound bad at all and would even call it a very a good sounding solid state amp. Sorry to hear about your father as it sucks getting old.

I had the same problem with my REVV D20 mkii.  HT fuse tube blown due to 6v6 tube. It happens….

Sorry about your dad. Hope he does well.

We'll be praying for your dad! Keep that Orange on the dirty channel and rock out!🤐

Hey Martyn, at time 7:48, shouldn't you have changed the meter to read DC volts for pin 7 plate and then screen reading? The meter stayed on AC volts from checking filaments. I know the HT fuse was blown, but at that stage you didn't know that yet and was the next thing you checked. Simple mistake all of us who work on amps have made. After replacing the fuse, the meter was properly set to DC volts. Keep up the good work, love the channel.

YIPPIE....