Looking forward for the build

At some point you put 2 dummy wires in the tutter next to the hall sensor and say something like, we’ll get to these next. But I don’t see you getting to the actual sensors connected to those for now dummy wires. One is the oil temperature I guess? And what is the other one?

Awesome

Why don’t you use Criss-cross pattern of tightening bolts?

Bike is awesome 🔥🔥🔥

i love your work !! very nice

At 3:06, what parts of the engine did you use ceramic coating for? And what parts did you use powder coating for?
Thanks, beautiful build.

erg mooi gedaan!

Lovely work , I presume you use all new bolts and fixings. Can you share where you obtain them? Or do they come as a complete kit?

I can't wait for the next episodes. When's the next one?😊

Any reason for using loctite 510 instead of 3-bond 1209?

I sthere any way you could run this engine with a chain drive? could it be turned sideways, I was thinking of using another full frame with the BMW 100 engine but want to get rid of the shaft drive? I have not seen enough of the engine up close to know what would be involved?

Can I change the front crankshaft seal through the ignition Timing plate?

Hey, Mister, do you need a quick shift sensor?

Can I buy this engine from you?

pregunta...por qué no puso empaque......y uso silicona ...la cual tapa conductos y adiós motor???

Rear main seal should not be flush

Cool, that the ECU still works on these "old" bikes.

Oh brother... Tell me you didn't tighten those screws in the order you showed.

Please get a quality microphone 🎙️, the audio is terrible and so is the music 😎

Did you rebuild the rotating assembly?