OpenTube

THE ULTIMATE PANEL SAW ( PART 1 of 2 )

Jhon Arief

46,210 views

#TheUltimatePanelSaw #JhonArief

To help me handle large board panel cutting that my table saw fence can not handle so I deside to build this vertical panel saw with more cheap and affordable materials using 608z bearing instead using expensive linear bearings, with the same precision and durablility
This is part 1 of 2
I hope you guys enjoyed

Materials that we need :
1. Square steel tube 3cm x 3cm x 150cm = 2 pcs (1.2mm thick )
2.Square steel tube 1.5cm x 1.5cm x 9cm = 8pcs (1.2mm thick )
3. M8 threaded rod 9cm length = 20 pcs
4. 608z bearings = 20 pcs
5. aluminum plate 40cm x 30cm x 5mm thick
6. A lot of M8 nut at least 130 pcs
7. 150cm x 80cm x 18mm Plywood
etc

Ultimate panel saw part 2 : ULTIMATE PANEL SAW PART 2 OF 2

Email : jhonariefdiy@gmail.com
Page : Facebook: workshopjhonarief

20 Comments

@Frank_Pelosi 4 years ago

Great job

@khldkhld857 5 years ago

Good work

@javiersolisbolivar3339 5 years ago

Nice

@James-m6n4x 5 years ago

Thank you

@antonioluizgoncalves6686 5 years ago

Muito Top seu projeto parabéns 👏

@barryeason749 2 years ago

Bravo! I haven’t even finished watching this video and had to comment immediately that this was an exceptionally well made presentation…have subscribed and will share, more importantly I have been inspired to replicate this project and that in turn will make me a more confident and creative woodworker 👍👍👍👌👌👌

@likeinterior9619 5 years ago

Kelas Wahid kie

@rakhmatfadlly1556 5 years ago

Mantappp

@joseruiz-cc1mt 1 year ago

Le faltaron tuercas y tornillos..

@ouchymytoe 4 years ago

You should probably use red ThreadLock—or at least lock washers/nuts.

@GeekItalian 2 years ago

What are the round black things? Are they rubber washers? You have them in order in the middle section: nut, rubber washer, bearing rubber washer, nut.

@helmi_varotex 5 years ago

Top markotop👍👍

@mixbyJM 2 years ago

Mas kalo mau buat motong full triplek berarti hollownya panjang 244cm?

@over-devz 2 years ago

Mas, itu kalau Alumunium plate nya diganti PVC sheet apa bisa..?
Kalau bisa yang ketebalan berapa MM ya..?
Sama mau nanya itu alumunium nya beli dimana Mas bagus banget masih ada lapisannya..
Terima kasih..

@Şahanebilgiler-j8i 5 years ago

Hello my friend,
I also watched the second part of the super idea. You did a great job at economical cost. I think it's also the best panel saw. congratulations. greetings to see you.