Has anyone got a diagram to attach the JST-XH to the Dewalt charger pins?

Nice video. A wiring diagram would be helpful.

a break down of what to solder to make the wire harness and how to set up a drill battery W/ a Lipo would be great. I did this with my dewalt 18v but the 20v battery’s are different. Thank you very much

This is awesome. Ali Express has those Dewalt charger connectors for cheap.
Last time I had a pack out of whack I had to take it apart and solder balance leads to the cells to balance it with my RC charger. This is so much more convenient. I suggest making the power & ground leads different length to prevent a dead short or plug it into the charger before the battery.

Nice video!

The balance is quite difficult because each cell has 400 ohm resistor in series so the current is very low, like 15mA

Nice video.  Multi meter work better too.

Can u video explain how u diy the charger dewalt

awesome video. can anyone tell me how to make the charger run without the battery in the charger. thanks!!

about to solder xt-60 and 5s balance lead to the charger itself.
the battery connector has a pcb in the back, so should be easy enough.
with the balance lead and any RC charger this will make sense. hota D6 pro or any of the ISDT ones should do just fine charging and balancing the batteries.
pity that dewalt wouldn't make a proper CC\CV balancing charger. All the parts are already there, the connector already has all the pinout and everything. Just add $5-10 for the missing circuitry.

Very informative.  This answered questions I had on Li-Ion batteries.  Thank you!

How long to take fully chargered 5ah or 4ah?

Want to help me try to come up with a multi battery charger setup that can be marketed? Make a couple bucks for both of us maybe?

Very nice, I have a 4 dewalt 5ah battery's the charger does not charge. Possibly voltage to low, does your charger discharge the cells and charge them back up? To bring the charge back to normal?

Does anybody know what the TH and C3 terminals are on DeWalt batteries?

Can you tell me how to install the 3s balance lead. A diagram would be great. Thanks

I took my Dewalt battery charger and notice that only 4 of the 6 balancer pins are wired up. If this is the case then how are the Dewalt chargers balancing the batteries?

Hi bud ! I really like you 8x8 and all your other vids too ! Can you tell me what kind of engine module you have in it ? And what engine sound you are using ? And maybe point me in the right direction where to buy one ? Please check out my 8x8 ! And I thank you so much for the great vid ! Cheers , Dan , rcforever

is there any way to fix batteries that wont charge?

JOchsner hey man can you please send me the wire diagram you used to connect the balance leads the the old charger plug...i have the same old charger and want to do the same thing...