watching this today gains me a knowledge thru my repair journey, thanks you gain a subscriber.

Have a board now where someone was trying to do some HDMI work on the encoder. Haven't lifted up the shield yet on that but the board is dead like this. No beeps at all from power button or eject. It must've been powering on at some point for them to attempt a no display issue. Love getting boards with previous repair attempts 😂 good video as always. This board is at the bottom of my que but I may look into the south bridge as well on it.

Great repair again and very informative 👍🇬🇧

good info and learning

Great repair!
I have one sab-001 board that has the same behaviour, eject beeps but no power at all.
Using the power supply setup as yours it starts to initialise and then stays on the top A rating.
I’ve already replaced the Southbridge with a new one and no go. Exactly the same behaviour.

Interesting and well done.

Very good video !!

good job 🎉
can please upload sab-001 standby voltage digram😊

Very cool

amazing job , can you open a discord server to share your knowledge

Hey buddy nice video, u'r professional and im really enjoying your videos. Can you make video about fixing PS3 slim common problem power on for 1 sec and then power off. Cheers!

Very good content . Hello from Dominican republic , would you mind sharing any diagram you have related to PS4 ?

Can i send you my ps4 it has no power i just ordered a power supply I'm hoping thats the fix

Nice repair 👍, did you reballed the south bridge chip? Or did you replaced it?

Nice content! I'm following all of your videos as much as I can cause I have a broken SAC-001 wich is not turning on, 1 beep, blue light and thne off. In one of your videos you check the 1.2 vcore and 1.5 vram at least for a moment while you press the on button. In my case I'm not getting neither 1.2V on the cpu are nor the 1.5V on the ram. Any clue where to troubleshooti? Thanks again and amazing content!

Good video, what would happen if you measured and did not measure any voltage at those points?😅

Greetings brother, you repair blackmagiec devices whose HDMI/SDI outputs do not work correctly. I have an ATEM STUDIO HD and the multiviewer output is not functional, comments saying that it is the CPU or voltage so that the cameras can be seen in the multiviewer. Anything I can send you repair examples

Can you test the standby voltages using the standard ps4 power supply?

Hello, thanks for the video. One question: I have a fat 1001, with memory error 0-1 and 7-6, I have changed many, I have changed the motherboard, but there is no way to repair that error, I have taken memories from another motherboard that does work. Any recommendations on the memory changes of those boards that have 16?, Regards

Thanks for everything .  I have a question. What if the Rt5069 has none voltage anywhere?